Included hardware: (3) 1/4"-20 button head screws, (3) 1/4" flat washers
Included items: Accessory mounting plate, Mounting bracket, Dual USB cable
First lift and remove the rubber compartment liner.
Next remove the two screws shown here using a 7mm socket.
Insert the mounting bracket in the orientation shown and secure it reusing factory hardware.
If you plan to install the provided USB cable you can now determine the best routing path to your intended power source. This can be a factory usb power port in the dash or an aftermarket 12v-5v usb adapter and this step will vary for each installation based on your preference and accessory power needs.
Route the cable ends through the top of the accessory mounting panel.
Pull all slack through and press the USB adapter tight into the rectangle cutout.
You can now route the USB cable ends to the desired power source location.
Line up the panel and install the 1/4" hardware. Start all 3 fasteners then tighten with a 5/32" hex.