Step by step on how to install the Fridge Slide. Please read all steps carefully before starting the install.
Installation Video: https://www.youtube.com/watch?v=JomIwPvkRSk
Questions or Support:
Phone: 269-353-1184
Email: info@jcroffroad.com
Check that you have all of the parts shown before starting.
Check that you have all of the hardware shown before starting.
Bolt each slide to the inside of the floor mounts with the red handles pointing out. Use 4 short 1/4 inch button heads, washers and flat nuts per side, with the blue Loctite on the bolts before tightening. Extend the slide to reach the inside holes.
Video timestamp: 0:16
Bolt the assembly to your floor through the bottom mounting holes on each side, using the longer 1/4 inch button heads and washers into the nutstrips. See the product page and install video for your vehicle specific floor system.
Video timestamp: 0:32
Choose upright or upside down for the U-shaped platform. A fridge wider than 18 inches goes upside down so it can overhang the sides, and it will sit 3.5 inches taller. Mount the platform to the slides with 1/4 inch button heads, washers and flat nuts.
Video timestamp: 1:04
With the platform on the slides in your chosen orientation, bolt the back piece to the platform using 1/4 inch button heads, washers and nuts, as shown.
Video timestamp: 1:22
Bolt the front bracket on with 2 button heads, washers and flange nuts. With the tray upright, this hardware is temporary until the handle is built in step 6. Upside down, use the bottom holes and leave it in place.
Video timestamp: 5:23
Build the handle around the red latches. Run 4 button heads through the PRESS bracket into the pem nut bracket so they sandwich the red grab handles.
Video timestamp: 9:12
Place the cover over the assembly with 6 button heads, washers and flange nuts. With the tray upright, remove the step 5 hardware first and reinstall it over the cover piece.
Video timestamp: 11:17
Your fridge slide is fully assembled. Set your fridge in place and strap it down through the front and back tray slots, using the fridge handles.
Video timestamp: 11:33
Confirm all hardware is tightened. Congrats! Your installation of the Fridge Slide is now complete. Enjoy!
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems