Included parts: (2) Victory 4x4 Billet Recovery Points, (4) M12 x 50mm Class 12.9 Hex Bolts, (4) 1/2” SAE Flat Washers

Start by removing the (2) M12 bolts as shown above with a 17mm socket. Removing these allow the factory tie down points to be removed. Repeat on the other side of the vehicle.

Next, using (2) of the supplied M12 bolts and washers, loosely install the Victory 4x4 Billet Recovery Point into the factory holes. Be sure to square up the part with the vehicle, and then tighten with a 19mm socket. Repeat on the other side of the vehicle.

You’re done! Add some hard (or soft) shackles to the recovery bag, and enjoy the peace of mind that you can be yanked if need be!