Step by step on how to install the Viper Cut Protection Wings on the 5th Gen 4Runner! Questions or Support: Phone: 269-353-1184 Email: info@victory4x4.com
Included Parts:
Included Hardware:
Begin by loosely mounting the support backet to the bottom side of the flange on the cradle as shown. Do this using the 1/2"-13 hex heads, washer and flange nuts.
Loosely bolt the wing to the support bracket using the 3/8" bolts, washers and flange nuts.
The support bracket hardware can be tightened through the cutout in the bumper.
Depending on how much plastic was cut, it may be easier to acces the bolts through the wheel well.
At this point adjust the position of the wing until it is in the desired position and tighten all hardware into place.
The fender liner will need to be trimmed. The grey line in the image is a good place to start. From there, more can be trimmed as necessary.
A notch such as the one shown in the image will need to be cut so that the fender liner can be slipped into the wing.
Slip the fender liner into the wing. Trim more if needed.
Confirm all hardware is tightened. Congrats! Your installation, is now complete. Enjoy!
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems