Back

INST: VCCC-3G-EDC

A A+ A++
Move your seat all the way back to make as much room as possible before installing the panel. Line up the panel so its flush with the center console. Mark the screw holes with a pick or a sharpie.
Use a drill bit or a pick to puncture a hole into the plastic but make sure the pick is smaller than the screw or use a 1/8” drill bit. Be sure you only drill deep enough to get the screws started.
Install the panel using a Phillips screwdriver. Use 1 screw and 1 spacer per hole. The Panel will use 4 screws and spacers, with the spacers going on the back side of the molle panel. The two bigger spacers will go to the rear two most holes, and the smaller spacers are for the front two wholes seen here. 
Do not over-tighten the screws but make sure they are snug. When you have completed 1 side, repeat the same steps on the other side. Look at the pictures Above to make sure your panel is installed just like ours.

HELP CENTER

Articles & Guides

GembaDocs Onboarding SOPs

GembaDocs Onboarding SOPs

15 Min - SOPs, Guide

New: How to Create, Assign and Track Training Courses

New: How to Create, Assign and Track Training Courses

6 Min - Guide

Learn GembaDocs

Learn GembaDocs

2 Min - Guides and Video

SOP vs Advanced SOP Guide

SOP vs Advanced SOP Guide

10 Min - Guides and Video

Explore

Support Hub

Lean Cave

GembaTalk

More Resources

Bugs & Improvements

Suggest an improvement, or report a bug, direct from the app/platform.

API Documentation

Connect GembaDocs with external systems