This product requires the prior installation of the Victory 4x4 2024+ Tacoma Front Blitz bumper
To make the cut will first require marking out three points on the bottom of the front fascia, along both sides.
These measurements are to be considered a starting point, and additional trimming and/or fine tuning of the cut may be necessary to achieve an ideal fit and gap for the wings. Take time to ensure the cut is marked carefully and remember that is safer to err on the side of cutting lower on the body initially.
The cut being marked will be following closely in line with the bend in the front bumper just above the three Viper Wing mounting slots.
For the first point, begin by applying a strip of masking tape along the side of the Blitz bumper on the fascia.
Using a flexible tape measure, hold the end flush with the sharp edge of the body line, right at the front point where it creates a shallow internal corner.
Measure down, holding the tape vertically across the fascia, and make a mark on the tape at 8-3/4".
After marking, verify that the measurement is correct.
The second point will be measured starting from the convergent point of the fender-to-fascia seam, and the bottom edge of the headlight.
Once again using the flexible tape measure, allowing it fall vertically and follow the contour of the fascia, start from the point called out in the previous step and make a mark on the masking tape at 13.25".
Make the mark right at the edge of the fender flare.
Double check this measurement once more after making a clear mark.
The third point will be measured from the intersection point of the fascia-fender seam and the outer profile of the fender flare where it crosses that sea, as indicated in the image.
Apply another strip of masking tape along the fender flare tangent to the wheel opening, directly below the measurement starting point.
Again, allowing the flexible tape measure to fall vertically and hug the contour of the fender flare.
Make a clear mark on the tape at 11.25"
At this point you should have something like these three points marked out on both sides of the fascia.
The next step is to "connect the dots." A laser level that can lock the beam will help with the step.
A line represented by the flexible tape measure will need to be created between the first and second points.
Using the edge of fine-line to follow the projection of the laser to create a cut-line, connect the two points.
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems