Step by step on how to install the Bronco Pet Divider. Please read all steps carefully before starting the install.
Questions or Support: Phone: 269-353-1184 Email: info@jcroffroad.com
Check that you have all of the parts and hardware shown before starting.
Hardware pack: 046-0146 (every bolt, nut and washer is listed in the bill of materials picture).
Assemble the three panels by setting the middle panel over the two outer panels and bolting them together with the 1/4-20 x 3/4 inch button heads and flange nuts.
Mount the side brackets to your rear MOLLE panels with the provided hardware. The face with the holes goes against the rear MOLLE panel and the face with the slots points toward the front of the vehicle.
With the panels assembled and the brackets mounted, loosely bolt the panels to the brackets.
Stick the 3M adhesive to the top of the small bracket and install it into the two holes in the top of the middle panel. Lift the panels as high as they go so the adhesive sticks the bracket to the roof, then hold them there while you tighten all the hardware.
Congratulations, you have completed the install of your new Bronco Pet Divider! Enjoy your new product.
Questions or Support:
Phone: 269-353-1184
Email: info@jcroffroad.com
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems