Step by step on how to install the Maverick Console MOLLE Panel. Please read all steps carefully before starting the install.
Installation Video: https://www.youtube.com/watch?v=h7jfACmNueE
Questions or Support:
Phone: 269-353-1184
Email: info@jcroffroad.com
Check that you have all of the parts shown before starting.
Check that you have all of the hardware shown before starting.
Line the panel up on the side of your center console, driver or passenger side, matching the curve and spacing to your liking. Once it looks right, use a punch or Phillips screwdriver to press and mark the four smaller mounting holes in the plastic.
Video timestamp: 0:15
Remove the panel and thread the provided screws into the marked spots to establish the holes, then take them back out. Don't punch too far through the plastic. You can also start the holes with a drill and a 1/16 in bit.
Video timestamp: 2:26
Place the panel back in line with the holes with the spacers behind it. The longer spacer and screw go at the top rear point. The 2 shorter spacers and screws go on the left (driver) side of the panel and the 2 longer ones on the right. Thread all 4 screws in until snug and secure, without over tightening.
Video timestamp: 2:41
Confirm all hardware is tightened. Congrats! Your installation of the Maverick Console MOLLE Panel is now complete. Enjoy!
15 Min - SOPs, Guide
6 Min - Guide
2 Min - Guides and Video
10 Min - Guides and Video
Suggest an improvement, or report a bug, direct from the app/platform.
Connect GembaDocs with external systems
