Installing the Victory 4x4 Tacoma Heavy Duty Bed Rack | 2nd, 3rd & 4th Gen (2005+) Youtube Video: https://www.youtube.com/watch?v=k56BHSMnGIg
Mount the Bed Rail Brackets: Two bed rail mounting brackets are required; one per side. Set the bracket in place on the bed and push it tight against the bed rail. Line it up front to rear.
Option A: Trucks with a factory accessory/trail rail. (Steps 8 - 11) // Option B: Trucks without a factory rail (GMC Canyon, Chevy Colorado, etc.) will be on step 12.
Slide the rail cap forward; press the tab and slide it back to remove.
Install two 5/16" carriage bolts into the bolt plate.
Slide the bolt plate into the trail rail. Move the bracket temporarily out of the way, slide the plate down until it lines up with the two vertically slotted holes in the mount, then feed it back in.
Install 5/16" washers and flanged Nylock nuts.
Option B: Trucks without a factory rail (GMC Canyon, Chevy Colorado, etc.). Use the alternate clamp-style bracket, angled flange facing up.
Install two carriage bolts on the back side. Slip the bracket in behind the mount.
Install the same washers and flanged Nylock nuts.
Using a 1/2" socket/wrench, press the mount up so it clamps on the bed rail side, then tighten. Note: mounting profile may vary slightly by rack version; don't worry if hole count looks different than shown. Tighten with a 1/2" socket/wrench, but leave slightly loose for now to retain front-to-rear adjustability. Repeat this entire step for the front position and the opposite side, then reinstall the end caps.
Note: mounting profile may vary slightly by rack version; don't worry if hole count looks different than shown. Tighten with a 1/2" socket/wrench, but leave slightly loose for now to retain front-to-rear adjustability. Repeat this entire step for the front position and the opposite side, then reinstall the end caps.
Gather the four trim plates: rear logo plate (top front), bottle opener (top rear), Victory logo, and accent plate (bottom).
Each plate installs the same way: 1/4" button head bolts, black washers, and serrated flange nuts from the underside.
There's slight play in the mounting holes; press each plate fully up or down so it sits parallel, then tighten both bolts. Use a 5/32" hex to tighten
Repeat all four plates on the opposite side rail.
There are three brackets per rack: front, rear (identical to each other), and a center bracket (slightly different).
Use 5/16" bolts, washers, and flange nuts (bigger than the logo hardware).
Top tabs bolt through two slots; the side mount bolts through three slots. Tip: It's easier to install this hardware before placing the trim logos; the logos will hide these bolts afterward.
Slide the bracket in on the bottom side of the flange, line up all five mounting locations, and install the 5/16" hardware.
Hidden-side bolts run inward with nuts toward the outside of the rack (covered by logos). Top bolts install top-down with nuts on the inside. Thread hand-tight only front/rear adjustment slots need to move freely during final install. Repeat for the front bracket.
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems