Step by step on how to install the EVO Front Bumper on the 3rd Gen Colorado ZR2! Questions or Support: Phone: 269-353-1184 Email: info@victory4x4.com
Included Hardware:
Begin by removing the (7) bolts retaining the front skid and set aside.
Remove the plastic access panels in the front of the fascia to expose the upper bolts of the skid plate reinforcement.
Remove the both (2) bolts through the access hole using an extension to reach the fastener
Remove the (2) bolts retaining the bottom of the skid plate reinforcement.
Remove the (2) bolts retaining the front recovery loops on both sides.
Remove the (4) Torx screws attaching the bottom of the fascia just in front of the Active Aero Shutter assembly
Remove the fasteners retaining the forward half of the inner fender liner on each side of the truck so that they may be pulled out of the way.
With the inner fender liner pulled back, disconnect the fascia wire harness plugs. There are (3) on the passenger side.
Ensure that the chassis end of the harness retainers are unsnapped from the fascia anywhere that the are connected.
Remove the (2) screws fastening the plastic internal lower fascia support the the steel core support tie-in bracket as show. Do this for driver and passenger side.
Gently unsnap the fender flare on each side just beyond the parting line, far enough to allow removal of the fascia unimpeded.
Remove the (4) Tors screws retaining the upper portion of the fascia, under the hood, just above the grill.
Lift the grill shell up and pop each corner off of the molded retainer studs.
Unsnap the fascia at the parting line by popping it out of the retainer at the front of the fender. Carefully avoid scratching the paint on the plastic retainers on the back of the flare. Do this for both sides.
Continue along the front on both sides, popping the fascia out of the retainers below each headlight.
Unseat the fascia from the retainers behind the grill area by gently but forcefully pulling directly away front the vehicle.
Finally, pop the two remaining retainers on each side below the grill by pulling directly outward, similar to the last step. Be careful to not drop the fascia. Assistance may be helpful with this.
With the fascia assembly removed, disconnect any harness retainers that connect to the lower plastic inner structure.
Remove the (3) fasteners holding the lower fascia structure to the painted upper fascia on each side.
HELP CENTER
Articles & Guides
GembaDocs Onboarding SOPs
15 Min - SOPs, Guide
New: How to Create, Assign and Track Training Courses
6 Min - Guide
Learn GembaDocs
2 Min - Guides and Video
SOP vs Advanced SOP Guide
10 Min - Guides and Video
Explore
Support Hub
Lean Cave
GembaTalk
More Resources
Bugs & Improvements
Suggest an improvement, or report a bug, direct from the app/platform.
API Documentation
Connect GembaDocs with external systems